Controlador de servos 16 canales

[BuenasNoches]

  20150728_113533.jpg (Tamaño: 216.2 KB / Descargas: 198) Connected completely:

[BuenasNoches]

Tried different setting in software. Can you place the setting wich work?

[BuenasNoches]

IT WORKS!

[Blasphemor]

Did you move multiple servos?

[BuenasNoches]

No. Able to move single servo's by using the shift-bars and by some commands.

Have found Chinees manual, only. To be continued...

[BuenasNoches]

Mmm...no progress anymore....

I'm not happy I bought this item,altough it was 8 euro.

I need a controller wich can be controller by pc but with own software. So the controller has to come with a libary containing instructions for e.q. Delphi C-language etc etc... and finaly controlled by raspberry pi.

[Blasphemor]

Mmm...no progress anymore....

I'm not happy I bought this item,altough it was 8 euro.

I need a controller wich can be controller by pc but with own software. So the controller has to come with a libary containing instructions for e.q. Delphi C-language etc etc... and finaly controlled by raspberry pi.

I think the same, it is a fuc...g She...

[BuenasNoches]

Yes, Im done with that trash. 8 euro's trough the drain...

Wel, good news. I'm about to step into the world of the Raspberry Pi. Got it allready as a gift!
Few euro's and you have a pcb with 16 or 32 lines for servo's....and you can programm them in different
languages in the way you want, single, simultanusly, groupwhise etc etc.

[BuenasNoches]

Just an example:

http://www.pridopia.co.uk/pi-9685-2-lp.html