This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
DUDA tmc2130 SPI shield
#1
Hola, gracias por leerme, la cosa es que me he comprado unos tmc2130 V1.1 SPI, actualmente uso A4988, y la placa es la ramps 1.6+, osea que no tengo problema con el SPI, la cosa reside en ¿Debería comprar unos protectores para estos drivers o así, estarán bien?
  Responder
#2
hola normalmente es aconsejable ponerles ventilador para enfriarlos, pues se suelen calentar
saludos
  Responder
#3
Si, con los A4988 ya les he puesto ventilador, pero la pregunta reside en si deberia poner protectores como estos:

[Imagen: tmc-shieldjpg.jpg]
  Responder
#4
no veo bien en la foto, pero si te refieres a los disipadores que van pegados encima, sin duda a si facilitan la disipacion del calor

saludos
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  DUDA problemas con cnc shield y arduino nano Pigarchu 11 4,315 22-02-2022, 09:22 AM
Último mensaje: TonyTren
  Cálculo de Vref y X_CURRENT para un controlador TMC2130 ChesuCR 5 2,735 26-05-2020, 03:06 AM
Último mensaje: xexicarrera
  TMC2130 me ha incrementado el tiempo de impresión. PKTRacing 5 1,849 15-04-2020, 05:45 PM
Último mensaje: prusa
Exclamación DUDA TMC2130 y A4988 Inderlard 5 1,610 21-11-2019, 12:12 AM
Último mensaje: Simemart
  Problema de avance en eje Y con CNC shield y DRV8825. antarjcor 2 1,582 17-10-2019, 03:47 PM
Último mensaje: antarjcor