This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Como puedo solucionar el error TO senser abnormal
#1
Hola buenos días,

Tengo una Anycubic Chiron y ayer cuando la encendía para imprimir me aparecía el error TO senser abnormal revise que las conexiones visibles estuvieran bien conectadas(Falta revisar conexiones de la placa), pero me seguía dando el mismo error.
Entonces lo que hice fue cambiar el fusor y ahora el error que me da el Cold Extrusion Prevented, auto heating on.

¿Alguna idea de como solucionarlo?

Un saludo y gracias de antemano.
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  ¿Puedo conectar la cama caliente al extrusor 2? Penitas 9 4,888 17-03-2018, 07:14 PM
Último mensaje: Penitas
  PROBLEMA ¿Puedo cambiar la lógica de un ENDSTOP sin temor a quemar nada? mokitochan 1 1,450 19-12-2016, 01:09 AM
Último mensaje: mokitochan
  Puedo usar optoacoplador en DC? yeyeto2788 3 2,750 03-06-2014, 01:48 PM
Último mensaje: Triggerr
  [AYUDA] No se solucionar problema cama caliente. asgranda 30 8,540 29-11-2013, 07:14 PM
Último mensaje: AndySev