This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Problema con el eje z
#1
Hola chicos, tengo un problemilla, es mas molesto que otra cosas, haber si me podéis ayudar a resolverlo.

Desde hace 2 semanas que cambie el extrusor por que se me jodio el j-head, cada vez que imprimo, tengo que ajustar el hot end, por que se me levanta mucho.

un saludo
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  Problema con eje Z Julio_Radilov 5 0 28-09-2023, 01:52 PM
Último mensaje: Simemart
  CONSULTA Tengo un problema con el eje Z alan04 3 1,716 16-10-2019, 09:29 PM
Último mensaje: thepost
  Ender 3: Problema con salto en eje z para retroacción jaume12 2 4,036 06-08-2019, 07:23 PM
Último mensaje: pere_gs
  DUDA Problema raro con el eje Z en una Prusa i3Steel LGL 7 4,804 18-04-2018, 09:06 PM
Último mensaje: Simemart
  problema con el eje Z y autolevel homer32 6 4,062 04-01-2018, 07:14 PM
Último mensaje: Shellmer