This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
CONSULTA ENDER 3 IMPRIME MAL LAS PRIMERAS CAPAS
#1
[Imagen: imagen.png]

Mi ender 3 imprime mal las primeras capas, es como si extruyera de mas y haze lo de la foto. Alguien sabe por que puede ser? Gracias.
  Responder
#2
Hola, probablemente se deba a una temperatura en la cama demasiado elevada y/o a un movimiento irregular del eje Z.
Viendo esa foto del cubo, se aprecia la ondulación de las caras verticales perpendiculares al eje X, signo claro de husillo/s doblado/s o mal colocado/s.
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
Triste CONSULTA No lamina bien las capas Armstorm83 3 259 27-01-2023, 09:34 PM
Último mensaje: Simemart
Exclamación CONSULTA Mala calidad en las primeras capas maaxcabj 2 274 26-01-2023, 01:04 PM
Último mensaje: maaxcabj
Exclamación Errores entre las capas de mi impresión, ayuda. Ian Uriel 0 253 28-12-2022, 07:34 AM
Último mensaje: Ian Uriel
Exclamación Eje Z y primeras capas ender 3 Max LuisDi 1 716 22-10-2022, 01:22 PM
Último mensaje: Simemart
  CONSULTA [Ender3pro] Primeras capas (rayas) 77manuel77 0 2,079 18-04-2022, 06:47 PM
Último mensaje: 77manuel77