This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
ayuda para setearlo e imprimir cosas pequeñas
#1
Buenas, como andan?
somos principiantes en esto, y necesitamos una mano con el seteo y como funciona nuestra impresora.
tenemos una SE3D y nos manejamos con TINKERCAD y el CURA.
pero cuando realizamos trabajos con detalles pequeños no logramos que salgan bien, siempre el filamento se desprende o no imprime directamente.
No tenemos idea como solucionarlo
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  CONSULTA Prusa i3 que se para al imprimir redneck450 1 1,110 08-06-2018, 06:30 PM
Último mensaje: drow