This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
SpainLabs - Comunidad 3D, Arduino, Raspberry, CNC, y más   ›   Zona Impresoras 3D   ›   Firmware y Software   ›   openscad

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
openscad
tazma
Maker Junior
**

Registro en: May 2016
Mensajes: 105

Reputación: 1

Lugar: Bages ( Barcelona )
#1
10-05-2020, 08:14 AM
hola me pueden decir como instalo fuentes nuevas en openscad 
gracias
  Buscar
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  Ayuda , Pernos y Tuercas con openSCAD RenoRain 2 1,459 11-01-2020, 03:35 PM
Último mensaje: RenoRain