12-02-2018, 10:52 PM
Buenas noches a todos, os comento mi problema
Tengo una Anet A8 y he actualizado a Marlin 1.1.8 y estoy en el proceso de calibración de la impresora
Desde Pronterface lanzo el comando
SENDING:M303 E-1 S60 C8
Y obtengo el siguiente mensaje
PID Autotune start
Error:Heating failed, system stopped! Heater_ID: bed
[ERROR] Error:Heating failed, system stopped! Heater_ID: bed
Errorrinter halted. kill() called!
[ERROR] Errorrinter halted. kill() called
En la pantalla de Arduino en las pestaña Configuration.h he verificado que tengo activado el PID y desactivado el BED_LIMIT_SWITCHING. El MAX_BED_POWER, tambien lo tengo activado
#define PIDTEMPBED
//#define BED_LIMIT_SWITCHING
// This sets the max power delivered to the bed, and replaces the HEATER_BED_DUTY_CYCLE_DIVIDER option.
// all forms of bed control obey this (PID, bang-bang, bang-bang with hysteresis)
// setting this to anything other than 255 enables a form of PWM to the bed just like HEATER_BED_DUTY_CYCLE_DIVIDER did,
// so you shouldn't use it unless you are OK with PWM on your bed. (see the comment on enabling PIDTEMPBED)
#define MAX_BED_POWER 255 // limits duty cycle to bed; 255=full current
¿Por qué no me deja realizar el calibrado del PID de la cama? Se os ocurre cual puede ser el motivo.
Si desde Simplify3D le doy a que caliente la cama lo hace correctamente
Gracias de antemano a todos.
Tengo una Anet A8 y he actualizado a Marlin 1.1.8 y estoy en el proceso de calibración de la impresora
Desde Pronterface lanzo el comando
SENDING:M303 E-1 S60 C8
Y obtengo el siguiente mensaje
PID Autotune start
Error:Heating failed, system stopped! Heater_ID: bed
[ERROR] Error:Heating failed, system stopped! Heater_ID: bed
Errorrinter halted. kill() called!
[ERROR] Errorrinter halted. kill() called
En la pantalla de Arduino en las pestaña Configuration.h he verificado que tengo activado el PID y desactivado el BED_LIMIT_SWITCHING. El MAX_BED_POWER, tambien lo tengo activado
#define PIDTEMPBED
//#define BED_LIMIT_SWITCHING
// This sets the max power delivered to the bed, and replaces the HEATER_BED_DUTY_CYCLE_DIVIDER option.
// all forms of bed control obey this (PID, bang-bang, bang-bang with hysteresis)
// setting this to anything other than 255 enables a form of PWM to the bed just like HEATER_BED_DUTY_CYCLE_DIVIDER did,
// so you shouldn't use it unless you are OK with PWM on your bed. (see the comment on enabling PIDTEMPBED)
#define MAX_BED_POWER 255 // limits duty cycle to bed; 255=full current
¿Por qué no me deja realizar el calibrado del PID de la cama? Se os ocurre cual puede ser el motivo.
Si desde Simplify3D le doy a que caliente la cama lo hace correctamente
Gracias de antemano a todos.