This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
SpainLabs - Comunidad 3D, Arduino, Raspberry, CNC, y más   ›   Zona SpainLabs   ›   General   ›   CONSULTA Problema simplify3d

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
CONSULTA Problema simplify3d
Tomas Karup
Maker Junior
*

Registro en: Feb 2021
Mensajes: 1

Reputación: 0

Lugar: Argentina
#1
19-02-2021, 10:26 PM
tengo un problema que cuando importo una pieza al programa se ven las paredes transparentes [Imagen: Whats-App-Image-2021-02-19-at-18-24-02.jpg]


Archivos adjuntos Miniatura(s)
   
  Buscar
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  Problema con simplify3D!! pram0s 3 1,763 25-09-2019, 09:48 AM
Último mensaje: sanchez98191