This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
trazo de laser discontinuo
#1
Buenas tardes, llevo observando, que cuando hago piezas con laser en goma eva o en papel o madera, en algunas curvas sobretodo cuando hay cambio brusco de direccion, quema mas del trazo normal , no se que debo modificar, tengo arduino uno , con grbl 0,9j, y en la configuracion de firm en $11 junction desviation 0.010 y en $12 Arc tolerance 0.002, debe ser estos parametros, pero debo aumentarlo o disminuirlo y cuanto .....
en aceleracion de x,y,z tengo 10mm/sec-2.
Muchas gracias. un saludo. luis
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  DUDA Laser GRBL no detecta mi máquina laser Hamman84 0 1,003 28-04-2022, 07:24 PM
Último mensaje: Hamman84
  CONSULTA Laser dévil en GRBL Laser fjfsanchez 8 5,600 27-01-2021, 08:53 PM
Último mensaje: Gussos