This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
problema
#1
Hola, tengo un problema con una ender 3 de un amigo, al intentar imprimir el extrusdor hace un autohome como siempre pero cuando se mueve hacia donde tiene que imprimir sube el extrusor pero no baja dejandpo ubn dedo de separacion de la cama, he tenido que forzar el eje z para bajharlo para que toque la cama.
alguna idea?
  Responder
#2
Supongo que no has modificado el marlin ¿verdad?
¿Con un auto home normal también hace eso o solo en el que inicia el gcode?
Y una cosa más, ¿has modificado el offset del eje z en el slicer que uses?
  Responder