This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
mueve 2 o 3 pasos a un lado y uno hacia el otro
#1
Hola estoy construyendo una prusa i3 con estos motores http://www.circuitspecialists.com/nema_1...h4807.html

y la placa arduino 1,4 ramps .
Estoy utilizando en pronteface y me conecto a 115200 .

Esta es mi configuracion
#define DEFAULT_AXIS_STEPS_PER_UNIT {53.33,80,2237.76,97.06} // default steps per unit for ultimaker Z:200*8/3
#define DEFAULT_MAX_FEEDRATE {500, 500, 5, 45} // (,mm/sec)
#define DEFAULT_MAX_ACCELERATION {9000,9000,100,10000} // X, Y, Z, E maximum start speed for accelerated moves. E default values are good for skeinforge 40+, for older versions raise them a lot.

#define DEFAULT_ACCELERATION 3000 // X, Y, Z and E max acceleration in mm/s^2 for printing moves
#define DEFAULT_RETRACT_ACCELERATION 3000 // X, Y, Z and E max acceleration in mm/s^2 for r retracts

Los motores los tengo trabajando a 200 ma cada uno. El inconveninte que tengo es que cuando muevo los motores hacen dos o tres pasos a un lado y uno al otro lado. Que puede ser el problema que tengo? Gracias por la ayuda .
  Responder
#2
Así a bote pronto podría ser que tengas los cables "mal ordenados"
Mira el video del gran obijuan a partir del minuto tres y medio
Cuando un hombre planta un árbol bajo cuya sombra sabe que no se sentará ha comenzado a comprender el sentido de la vida... o lo que es lo mismo... comparte!!!
  Responder
#3
hola queria agradecerte ese era el asunto estaban al reves . gracias
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
Exclamación CONSULTA Perdida de pasos Extrusor doble engrane Ender 3 JairoRC 3 0 26-07-2023, 10:07 PM
Último mensaje: Simemart
  Prusa ei3 he3d se mueve pero no imprime. apamaster 0 0 30-06-2023, 12:28 AM
Último mensaje: apamaster
Exclamación CONSULTA PERDIDA DE PASOS, AYUDA Ian Uriel 14 649 03-01-2023, 06:08 AM
Último mensaje: Ian Uriel
Bombilla Me sirve el DRV8825 o debo comprar uno con más capacidad? Jpatinoch 3 650 29-03-2021, 10:47 AM
Último mensaje: Simemart
  Otro nuevo en el undo Tcieza 4 749 22-03-2021, 10:14 PM
Último mensaje: Tcieza