This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
hacer hope-Z en slicer
#1
hola a todos quería preguntar como se hace u salto en z ya que estoy imprimiendo con flexible y me arrastra la capa al cambiar de pieza.
gracias de antemano
un saludo scooby
  Responder
#2
Lo haces con el Slicer que utilices. Por ejemplo yo utilizo cura y, si te he entendido bien, en este se llama 'Z Hop retraction', que slicer utilizas Scooby ?
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  CONSULTA Cabezal golpea eje z al hacer homing Modest 2 0 03-12-2023, 09:51 PM
Último mensaje: Modest
  Dudas entre hacer un upgrade a mi A8 o cambiarla aguedob 1 0 03-12-2023, 04:03 PM
Último mensaje: Simemart
  CONSULTA ¿Hacer que una impresión flote en el agua? Albsar 1 627 08-03-2021, 02:49 PM
Último mensaje: Simemart
  CONSULTA Problema eje Y al hacer Homing Demarras 3 1,131 03-09-2020, 05:02 PM
Último mensaje: dvera16
Triste ender 3 tiempo de impresion muy distinto al slicer dantechiapp 2 1,144 02-09-2020, 05:08 PM
Último mensaje: dantechiapp