This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Sujetando la bobina encima del marco
#1
Estoy en racha... y gracias a la idea de dasaki, sin tornillos.

[Imagen: cLQxYq9.jpg]

http://www.thingiverse.com/thing:159502

Espero que os guste.
  Responder
#2
Esta muy bien Mola

Solo tengo una duda he leído que la bobina encima del marco si esta completamente recta crea un movimiento y mueve el eje Z con lo que te salen regular las piezas.

¿Has probado a imprimirla y usarla?
  Responder
#3
A ver si esta foto responde a tu pregunta...

[Imagen: R9j2REC.jpg]

He intentado que este lo más baja posible sin tener ni idea de este efecto. Pero yo no noto nada.
Como puedes ver, a la derecha está el resultado de un enredo de fibra.

:gnomito:
  Responder
#4
Muchas gracias por el aporte, imprimiendo... xD
  Responder
#5
Gracias... hora de hacer pruebas...
  Responder
#6
Poner la bobina encima del marco, aunque es muy habitual, es un error. Genera una inercia en altura que empeora la calidad de las piezas.

  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  APORTE Soporte de Bobina para Impresoras Creality Sr. Kowi 2 1,392 27-10-2019, 07:36 PM
Último mensaje: jukillo
  Piezas para la impresora i3 - Marco sencillo OverCraft 33 13,607 24-02-2015, 08:38 PM
Último mensaje: dracon_jm
  Mi primer prusamodelo! Soporte eje Z - marco de 1cm o 6mm neoxM3 9 3,010 25-01-2014, 08:33 PM
Último mensaje: neoxM3
  [UPDATE] Soporte para arduino al marco Alcamprieto 10 3,731 25-10-2013, 02:50 PM
Último mensaje: renatotorcuato
  Soporte para fuente 20A al marco sin tornillos Alcamprieto 11 3,664 22-10-2013, 12:50 PM
Último mensaje: LuIsCrAcK