This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
(SOLUCIONADO) la temperatura de hotend no pasa de 240º
#1
Hola a todos,pues me pasa eso,tanto en manual,como cuando le doy a imprimir para llegar a los 240º le cuesta horrores, no se si esta fallando el calefactor del hotend,si es algun Mosfet o si podria ser algo del Marlin.

Por otro lado me pasa otra cosa que no entiendo,imprimo en PLA el cubo de calibracion y me lo hace bien,en cambio con ABS( a 230 grados pq no sube mas la temperatura) en vez de 1 cm de altura se queda en 8 milimetros.

Gracias a todos

Bueno pues al final lo de la temperatura era una pijotada,resulta que en la resistencia del hotend y en el alojamiento habia como una ceniza(no se si seria algun tipo de proteccion de la misma resistencia o alguna masilla de quien monto el hotend) que hacia que la resistencia no transmitiera toda la potencia calorifica al hotend.Fue limpiar eso y funcionar pefectamente.
Agradecerle a OverCraft que me sacara de dudas en cuestiones tecnicas sobre el Marlin y la electronica.
:aplauso:

En lo referente a la altura creo que se debio desconfigurar algo en el Marlin pues luego tampoco me hacia bien el cubo con PLA,ando peleandome con los valores en configuracion.h para dejarlo afinado.

:dale2: :dale2: :dale2:
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  ¿CÓmo funciona una SKR MINI para calentar hotend? RocaDiesel 2 366 04-12-2021, 11:19 PM
Último mensaje: RocaDiesel
  DUDA ventiladores de capa con doble hotend emiheli 4 1,426 12-02-2021, 12:35 PM
Último mensaje: emiheli
  Problema hotend y sensor al poner cama de silicona 220 Jesusev 3 1,440 15-04-2019, 03:42 PM
Último mensaje: Simemart
  CONSULTA Cables del HotEnd Javco 5 2,086 14-03-2019, 05:28 PM
Último mensaje: Javco
  Temperatura Hotend baja al imprimir zgz58 9 5,742 22-09-2017, 05:02 PM
Último mensaje: tximy