This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Problema con slicer
#1
Buenas,
Acudo a vosotros con un problema al pasar por el slicer una pieza. Utilizo el slic3r, y con otras piezas no me da problemas, pero con esta, deja la pieza a medias. Alguna idea de por que puede ser?? He probado con el cura, que nunca lo había utilizado, y salio un churro :roto2:

Así es como tendria que quedar:
[Imagen: 2jaglmf.jpg]
Y así es como queda:
[Imagen: 2my96s1.jpg]
Un saludo y gracias de antemano
Centrado en el blanco no te caes del banco  :mola:
  Responder
#2
Hola

Prueba a pasar el stl por Netfabb, ya que parece que tenga algun fallo. Recuerdo que tuve que hacerlo con alguna que otra del Inmoov cuando lo estuvimos imprimiendo
Tu tienda de Impresoras 3D filamento y componentes a un precio asequible. Repparts3D.com
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
Triste ender 3 tiempo de impresion muy distinto al slicer dantechiapp 2 1,144 02-09-2020, 05:08 PM
Último mensaje: dantechiapp
  hacer hope-Z en slicer scooby 1 924 13-08-2019, 07:32 AM
Último mensaje: OrtegoWRX
  Consulta Slicer Prusa Edition jphurtadom 2 1,339 25-04-2018, 11:27 PM
Último mensaje: jphurtadom
  Slicer first layer height Bertinolario 0 1,085 28-02-2017, 08:29 PM
Último mensaje: Bertinolario
  Configuracion Slicer CheddarOP 4 4,434 07-03-2016, 10:05 PM
Último mensaje: ICEM4N