This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 1 voto(s) - 1 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Primera capa no se hace correctamente....
#1
Llevo 2 días con este problema, he intentado volver a probar configuraciones que me funcionaban, diferentes alturas de capa y la primera capa nunca se me hace bien... ilustro:

[Imagen: 3pzPXOw.png]

[Imagen: iKXPv0L.png]

Alguna solución por favor? llevo 3 días con esto y ya no sé que mas hacer...
  Responder
#2
Hola, la primera foto no sé que es y en la segunda, si te refieres a que te quedan muy marcadas las líneas en la primera capa, es un problema de calibración de la altura inicial.
Déjala bien ajustada con la hoja de papel y fija la altura de la primera capa, en el programa de corte que uses, al valor que te dé el resultado que buscas.
  Responder
#3
Los perimetros los hace bien? O deja un espacio entre linea y linea? Que laminador usas?
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
Triste NO IMPRIME CORRECTAMENTE. Montesa_Impala 1 322 09-12-2021, 07:01 PM
Último mensaje: Montesa_Impala
  CONSULTA Filamento no se queda pegado y no hace forma. stiuws2628 3 695 22-10-2021, 02:47 PM
Último mensaje: Simemart
  TMC2130 hace cosas raras Inderlard 4 725 20-07-2021, 06:34 PM
Último mensaje: Inderlard
  CONSULTA Por que no funciona y hace ese ruido? sparrow 2 678 12-05-2021, 05:49 PM
Último mensaje: neoxM3
  Ender 3 - Extrusión directa hace "cleck" apares8 7 1,344 17-02-2021, 04:07 PM
Último mensaje: SolomeoParedes