This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Mil intentos y no lo consigo¡¡¡
#1
Hola a todos,

Llevo un par de días haciendo pruebas y pruebas y no soy capaz de solucionar el problema que publique en la sección de anycubic.
Lo pongo en el general, a ver si alguien me echa una mano. Decir que no pasa exactamente igual en todas las torres, la de la foto ws la más desfavorecida.

https://www.spainlabs.com/foros/tema-Ret...ossel-Plus

Gracias de antemano
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  CONSULTA PETG no lo consigo imprimir Kikedark 0 673 29-01-2021, 04:11 PM
Último mensaje: Kikedark
  DUDA No consigo estabilizar la temperatura Ender 3 phoenixyetinsons 8 2,975 24-11-2019, 12:16 AM
Último mensaje: Simemart