This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
KISSlicer 1.6.2. No avanza filamento
#1
Hola a todos!
He empezado a usar  la nueva versión de KISSlicer 1.6.2 y no consigo que  avance el filamento, ni que tenga retracción. Sabe alguien que parámetro tengo mal? 


[Imagen: Sin_t_tulo_1.jpg]


[Imagen: Sin_t_tulo_2.jpg]

Saludos
  Responder
#2
mmm puede ser un bug de esa version, yo utilizo la version de 64 bits 1.6 y no he tocado ningun parametro de la retraccion ya que de serie funciona de fabula, eso si observando no lo tenemos ni parecido...
te pongo mis parametros:
Destring : 4mm
vel: 65
wipe: 0
min jump: 5
trigger:10
z-lift:0
  Responder
#3
Hola NeoxM3!
Probaré a poner tus parámetros a ver que pasa.

Saludos
  Responder
#4
Al final me he quedado con 1.6.1 con esa funciona con normalidad.

Saludos
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  KISSlicer hectorri 39 13,955 09-11-2013, 02:40 PM
Último mensaje: WeSo