This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 1 voto(s) - 5 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Desesperado con los homing en p3steel(solucionado)
#1
Hola
Ya no sé qué hacer para hacer homing,por ejempo,en el eje x,x+ hacia la derecha e x- hacia la izquierda.Pues configurado en marlin el homing con parámetro -1 me hace el homing hacia la derecha!!.Si pongo el valor a 1,lo mismo va hacia la derecha,sólo cambia el sentido si invierto la lógica del endstop. Pero al pisarlo no se para...
Tengo cableado el Nc a S y el Com al - en la ramps...

Silucionado:conecte los endstop en NO, y cambié el pineado.
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  Problemas con el hot end (SOLUCIONADO) Mayl Nicolas 4 1,238 13-01-2021, 08:45 AM
Último mensaje: Mayl Nicolas
  Problema con los Nema 17 Smitter 7 2,818 30-01-2019, 09:49 PM
Último mensaje: Smitter
  Duda con los tl smoother fran_ 2 1,956 14-08-2017, 07:59 PM
Último mensaje: fran_
  el eje Y se para al hacer homing albertoteruel 2 1,378 19-12-2016, 06:10 PM
Último mensaje: albertoteruel
  prusa p3steel Cama Caliente Cortocircuitada (y problemillas varios) Pamorgon 6 3,000 19-02-2016, 10:53 PM
Último mensaje: Pamorgon