This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
DUDA placa MKS
#1
PCB Controller Board MKS Gen V1.4


esta placa es de 8 bits o 32 bits?
Que Marlin puedo cargarle?


Saludos y gracias.


[Imagen: 61tm61-Jn-A6-L-SL1000.jpg]
  Responder
#2
Tiene toda la pinta de ser la de 8-bits.
el manual lo tienes aquí: https://www.roboter-bausatz.de/media/pdf...aSheet.pdf

Si buscas la de 32 bits es muy diferente.

El marlin, pues en mi opinión personal:
- placa de 8 bits: marlin 1.1.9 bugfix
- placa de 32 bits: marlin 2.0.x la última.

Marlin 2.0 está muy mal optimizado para 8 bits, de hecho, todos los cambios mayores se han hecho para dar soporte a las placas de 32 bits. Los 8 bits están solo por compatibilidad. Sin embargo Marlin 1.1.x se desarrolló casi integramente para placas de 8 bits, por eso está más optimizado
Ulticampy V2: fundiendo plástico sin descanso...
  Responder
#3
Buenas hasta hace un rato estaba con la misma duda. Es de 8 bits, es increíble que no lo haya encontrado por ningún lado. Tuve que preguntarle a un vendedor. Saludos
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  CONSULTA mks robin e3d jacieldei 6 2,153 08-01-2021, 02:35 AM
Último mensaje: larvard
  CONSULTA mks robin e3d jacieldei 0 645 12-09-2020, 10:32 PM
Último mensaje: jacieldei
  CONSULTA mks robin e3d jacieldei 0 601 12-09-2020, 10:31 PM
Último mensaje: jacieldei
  Problema perdida de pasos eje Y ender 3 con MKS gen L croquers 8 2,452 13-06-2019, 08:23 PM
Último mensaje: croquers