This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 1 voto(s) - 2 Media
  • 1
  • 2
  • 3
  • 4
  • 5
DUDA Capas descentradas
#1
Hola,

Tengo una kossel y cuando imprimo piezas grandes cada capa me lo hace descentrado respecto de la anterior. Alguien sabe porque? Nusenuse

Un saludo
  Responder
#2
Unas imágenes no vendrían mal. Prueba que las poleas de los motores estén bien apretadas, o también prueba la potencia de los pololulus. Un saludo

Enviado desde mi SM-G935F mediante Tapatalk
  Responder
#3
Hola,



[Imagen: IMG_20170809_065648.jpg]

imagenes internet

Los tornillos están todos bien apretados, pero aun así me imprime así.
  Responder
#4
Pues como comenta dr.taly o tienes un problema mecánico o los motores pierden pasos. Comprueba si se arrega subiendo algo la corriente de los drivers.
  Responder
#5
Prueba también que el cristal de la base esté bien fijo, ya que si roza el nozzle puede girarlo como un tocadiscos y hace un efecto muy parecido.

El otro día imprimí un cubo que parecía una baraja de cartas en abanico xD
  Responder