This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Cura 2.4.0
#1
Parece que hay una nueva versión.

Alguien la ha probado? mejora en algo las impresiones?

https://ultimaker.com/en/products/cura-software

Saludos, Alvaro
  Responder
#2
Solo le veo esto intetesante... Aun le falta mucho para ser usable como el viejo

Cubic subdivision infill. This experimental new infill pattern works on a similar basis to cubic infill – but generates larger cubes further inside the mesh. It’s a great way to reduce material use and cut your print time, whilst maintaining structural integrity.
  Responder
#3
Hola a mi en este como el anterior,no me sale en preferencias para elegir que salga la pantalla de pronterface, como en las viejas versiones,para poner temperaturas,ademas le dado a imprimir una pieza y se ha puesto en marcha sin calentar ni cama ni extrusor,asi que le tengo aparcado
saludos
  Responder