This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
CONSULTA error al imprimir en una kossol mini
#1
al momento de imprmir piezas de gran tamaño no realiza la capa exterior de la pieza dejando al descubierto el relleno, en la visualizacion del gcode esta correta con todas las paredes, utilizo Cura v3.6 punta del extruzor 0.4mm 
altura de capa 0.3mm relleno al 10%      
[Imagen: IMG-20181211-170245.jpg]

Nusenuse
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
Pregunta CONSULTA PROBLEMA MINI HUECOS ENTRE CAPAS pablosenes 1 329 04-12-2022, 12:09 PM
Último mensaje: Simemart
  [solucionado] Problema eje Z. SKR Mini E3 silth 11 3,468 05-06-2021, 03:37 AM
Último mensaje: jquiroz
  Problema al compilar Marlin para placa SKR Mini E3 Aurican 14 4,063 28-04-2021, 11:57 PM
Último mensaje: erjavi_zgz
  el mejor material para imprimir una estatuilla? josssss 1 756 26-04-2021, 11:47 PM
Último mensaje: neoxM3
  Sin acceso a la tarjeta mini SD Juanillo 6 1,208 22-10-2020, 11:18 PM
Último mensaje: Juanillo