This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
CONSULTA ender 5 plus
#1
Triste 
holaa chicos, saludos ... tengo un problemon, adquirí una ender 5 plus, la pedí armada, me la entregaron probada y todo pero cuando la fui a ocupar, me comenzó a despegar las piezas, alcanzan 1 cm y las bota, el problema es q esta ultima vez me dejo la crema por q al dejarla sola se acumulo muchoo plastico en la boquilla y se metio por todas partes, bueno en fin no se que hacer, con que tengo q tener cuidado o si tienen algunas mañas las de ese modelo.. ayuda
  Responder
#2
Buenas,

Es muy probable que no tengas bien calibrada la cama de impresión.  Lo primero de todo calienta y limpia la boquilla. 
Luego calibra de nuevo la cama, échale adhesivo de impresión o en su defecto laca y prueba de nuevo. 

Un saludo.
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
Triste CONSULTA Ender 5 Plus quedo con pantalla congelada y no arranca diego gonzalez 5 1,097 12-01-2024, 04:45 PM
Último mensaje: felixtin
  Ender 3 V2 a Ender 3 S1 fvelez 6 425 30-12-2023, 12:49 AM
Último mensaje: Rulem
  CONSULTA SALVAR FIRMWARE ENDER 5 PLUS cambio placa guajiro2000 16 0 31-07-2023, 09:06 PM
Último mensaje: Simemart
  Nivelación Ender 5 Plus Nene3232 3 210 02-02-2023, 04:02 PM
Último mensaje: Simemart
  CONSULTA Ender 5 plus no imprime el gcode gastonf91 4 1,188 16-01-2023, 05:19 PM
Último mensaje: Rafa C@ndela