This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
CONSULTA SOLUCIONADO Solo me imprime la primera capa y se detiene
#1
Hola chic@s tengo un problemita con mi Anycubic i3 mega, y es que cuando imprimo no me termina la primera capa y se para ni siquiera vuelve a home, se me queda sobre la impresion.  
Ya desinstale el cura por completo, probé con otro laminador y lo mismo, lo mas raro que me dio por imprimir uno viejo que tenia guardado en la SD y si me funciono  
perdonen si ya había algún hilo por ah´pero no lo encontré gracias de antemano.



[Imagen: 20181124-202013-resized-2506.jpg]




[Imagen: 20181124-202038-resized-2505.jpg]
  Responder
#2
Hola, parece un problema de la tarjeta SD. Prueba a cambiarla por una nueva y/o de mejor calidad.
  Responder
#3
Si la SD no te lo soluciona... intenta subir a algun lugar el fichero gcode que intentas imprimir para ver si el slicer que usas te esta generando mal el codigo.
  Responder
#4
Provaste a imprimir por el cable USB en vez de por la SD
  Responder
#5
Bombilla 
Muchas gracias chic@s son unos maquinas  efectivamente era la tarjeta SD

Muchas gracias chic@s son unos maquinas  efectivamente era la tarjeta SD
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  Geeetech A10 se queda en "E1 Heating..." y no imprime Alcor 4 0 22-03-2024, 08:31 AM
Último mensaje: Alcor
  Artillery X2 no imprime Juanky 1 0 21-03-2024, 09:20 PM
Último mensaje: Simemart
  Prusa ei3 he3d se mueve pero no imprime. apamaster 0 0 30-06-2023, 12:28 AM
Último mensaje: apamaster
  CONSULTA ENDER 3 IMPRIME MAL LAS PRIMERAS CAPAS Otero 1 277 23-11-2022, 09:56 PM
Último mensaje: Simemart
  CONSULTA Error eje z no baja solo sube Alexmasi62 6 1,761 21-09-2022, 11:52 PM
Último mensaje: Simemart