This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
CONSULTA Rumba no funciona con LCD full graphics
#1
Hola makers, tengo un problema, tengo en mi impresora una placa RUMBA con LCD full graphics, el grande, y lo solté para cambiar unas cositas en la impresora, y cambiar el interruptor de la fuente y me hizo un corto con el interruptor apagado, lo cual no veo problema... el caso es que ahora la LCD no me funciona, he probado con dos o tres y enciende, veo los datos, pulso el encoder y entro al menu, pero si giro para navegar, se reinicia el marlin, he probado las conexiones con otro cable, a resubir el marlin y no funciona y se reinicia, como ultimo intento puse una lcd smart, la pequeña, y funciona todo perfecto con ella.
 
Que se os ocurre que pueda estar pasando? hay algun pin que se haya podido quemar y la lcd pequeña no utilice, y por tanto si funcione o algo que se os ocurra?
  Responder
#2
A posição Exp2 do LCD deve ser ligada na Exp1 da Rumba e deves rodar o cabo 180º na ficha da Rumba.
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  prusa i3 no funciona el motor y silvera 1 0 07-07-2023, 10:48 AM
Último mensaje: Simemart
Exclamación CONSULTA El motor del filamento en el extrusor no funciona correctamente alexramsal 4 1,000 11-08-2022, 10:47 PM
Último mensaje: juir
  ¿CÓmo funciona una SKR MINI para calentar hotend? RocaDiesel 2 366 04-12-2021, 11:19 PM
Último mensaje: RocaDiesel
  Cambio Endstop por 3dTouch y no funciona. Luz roja constante [Solucionado]. Mafer 15 1,987 13-09-2021, 09:09 PM
Último mensaje: Simemart
  CONSULTA Ramps 1.4 y LCD Full Graphics Controller mati1608 9 1,181 06-08-2021, 10:57 PM
Último mensaje: Simemart