This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
CONSULTA Modificar las condiciones de impresion para poder imprimir PLA humedecido?
#21
Listo, solucionado, no se cual sería el origen del problema pero he establecido los pasos por mm a 235 y va mucho mejor (estaba a 93, aunque CREO recordar que traía ese valor).

Muchas gracias por todo, he aprendido mucho con esto.
  Responder
#22
Me alegro que lo hayas solucionado.
Ulticampy V2: fundiendo plástico sin descanso...
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  DUDA PLA frágil Javier Goerlich 4 482 04-05-2022, 06:37 PM
Último mensaje: neoxM3
  CONSULTA [SOLUCIONADO] Primeras capas con reborde y exceso de PLA inviernomudo 19 1,534 01-02-2022, 07:08 PM
Último mensaje: pano
  Cambio de PLA = Pesadilla RockBlaster 2 548 16-08-2021, 12:47 PM
Último mensaje: RockBlaster
  CONSULTA No termina de imprimir las piezas LoboGris 2 936 09-07-2020, 06:49 PM
Último mensaje: LoboGris
  Problemas impresión Ender 3 PLA Ingeo Stormcloud 2 760 16-05-2020, 11:28 PM
Último mensaje: Bear