This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Ayuda anet A8 Plus
#1
Hola, hace poco he comprado una anet A8 plus y necesito ayuda en algunos aspectos, he intentado imprimir un reloj de pared, al principio empieza con una fina capa haciendo la figura, todo bien en esa parte se distinguen todas las figuras y lo hace con bastante precisión, pero cuando empieza a soltar más filamento para empezar a darle volumen los números los hace deformes, las letras igual, un cirulo se convierte en un cuadrado por que no se fija bien y así con todas las partes. 


Alguien puede ayudarme con este problema?

Uso ultimaker cura  4.5 y la configuración Prusa i3 MK2

Si alguien puede decirme que configuración necesito en ajustes de impresora, del cabezal y el gcode también lo agradezco



[Imagen: cura-configuracion.png]


Saludos y gracias por vuestro tiempo
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  Pantalla Ender 5 Plus Muerta? felixtin 15 0 20-01-2024, 12:03 PM
Último mensaje: Simemart
  Problemas con Ender 5 Plus Iruvic 8 2,799 18-03-2021, 04:35 AM
Último mensaje: Hectespinoza12
  Ayuda anet A8 Plus Pitu71 5 3,297 17-04-2020, 09:48 PM
Último mensaje: Pitu71