This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 1 voto(s) - 1 Media
  • 1
  • 2
  • 3
  • 4
  • 5
CONSULTA Es posible mejorar la última capa?
#1
Hola buenas tengo una Artillery se x1 y utilizó cura. Tengo dos problemas uno es que la capa superior no está muy alisada y si por ejemplo quiero que esté alisada pero hay un símbolo letra etc se alisará la última capa pero no la última capa del fondo del símbolo, letra etc. El otro problema es que en las paredes de la pieza se nota las líneas del relleno.
Espero que me puedan ayudar. Muchas gracias.
[Imagen: 15744601593682120298109343361014.jpg]

[Imagen: 15744601971103873026385970855867.jpg]

[Imagen: IMG-20191122-230938.jpg]
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  Creality Ender 6 - Impresión con marcas. ¿Cómo mejorar? javichuteck 6 0 15-01-2024, 11:26 AM
Último mensaje: Simemart
  Marcas del nozzle en la última capa galiana 2 263 18-01-2023, 08:25 PM
Último mensaje: galiana
  Impresion de engranajes pequeños, posible? posada_posada 1 399 17-11-2021, 04:21 PM
Último mensaje: grafisoft
  CONSULTA es posible utilizar el controlador paso a paso s42b en una ramps 1.3? cerverus 10 1,677 10-10-2020, 10:43 PM
Último mensaje: Simemart
  DUDA ¿Es posible pegar Filaflex? BorjaBl 2 1,128 30-01-2020, 12:53 AM
Último mensaje: dasafur