This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
el filamento, expulsa el tubo del alimentador
#1
Muy buenas tardes tengo un problema con mi impresora FLSUN PRUSIA I3 , cuando intento imprimir el filamento no sale por la boquilla si no aparentemente se atasca y la fuerza hace que el tubo donde va el filamento se salga del conector.
[Imagen: bolado.jpg]
no se si es un tema de velocidad y queria ver si alguien me podia ayudar a solucionarlo o saber si a alguien le a pasado algo similar
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  el filamento, expulsa el tubo del alimentador evo123 2 1,217 28-10-2019, 02:54 AM
Último mensaje: evo123
  Problema con la extrusión del filamento / No se adhiere correctamente. Ana13 5 2,389 13-07-2018, 04:04 AM
Último mensaje: buratatxo
  Se pueden disimular las pasadas del extrusor con el filamento? Kuassimodo 10 3,348 17-12-2017, 02:23 PM
Último mensaje: Kuassimodo