This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
APORTE MOD DANGER para perfiles de impresora 3D
#1
Buenas Foro:

He confeccionado un MOD basado en las típicas líneas de peligro amarillas y negras. Se compone de una "tesela" que se coloca entre los huecos de los perfiles y da lugar a este efecto tan molón. No roza en ninguna parte de la máquina, siguiendo esta funcionando con normalidad. He subido el archivo a thingiverse, por si queréis imprimirlo para vuestras impresoras. Estoy confeccionando otros diseños que también compartiré. 

Enlace archivo MOD thingiverse: https://www.thingiverse.com/thing:3891570
Instagram: @mi_escaner_3d
Página web: https://miescaner3d.wixsite.com/website

[Imagen: danger-stripes-1.jpg]

[Imagen: DSC-0324.jpg]

[Imagen: 12342321.jpg]

[Imagen: striper-2.jpg]

Un saludo,

Francisco
  Responder
#2
muy guapo, si señor. Yo tengo una muestra de filamento glow in the dark y se me habia ocurrido hacer algo como lo tuyo para la mi impresora.
  Responder
#3
(06-10-2019, 09:30 PM)dasafur escribió: muy guapo, si señor. Yo tengo  una muestra de filamento glow in the dark y se me habia ocurrido hacer algo como lo tuyo para la mi impresora.

Muchas gracias dasafur, me alegro de que te guste. Con ese filamento que comentas tiene que quedar muy bien. Si lo imprimes házmelo saber, me gustaría ver cómo queda. Por cierto, acabo de terminar otro MOD, inspirado en la película MATRIX, por si le quieres echar un vistazo. https://www.thingiverse.com/thing:3892312


[Imagen: DSC-0433.jpg]



Un saludo.
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
Fotografía Proyecto impresora tipo Ultimaker con perfiles V Slot bncs 6 4,702 30-11-2015, 12:05 AM
Último mensaje: bncs
  [Mod Prusa I3] IF Printer biketrial981 18 5,870 20-06-2014, 08:10 AM
Último mensaje: Imago