This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
DUDA Impresora se enfría al iniciar impresión
#21
La cama es de 220v o esta conectada a la placa 24v o 12v. Prueba hacer una impresión calienta la cama y después desactivala. Haber si va ser que la F.Alimentacion no pueda. Con la cama caliente y hotend.
Si no ya ni idea.

Enviado desde mi SGP712 mediante Tapatalk
  Responder
#22
La cama es de 110V, he probado haciendo el calentamiento y luego al darle home enseguida comienza a bajar la temperatura, cuando termina el home ahí vuelve a subir la temperatura a la seteada.
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  La cama se enfría en forma automática jsarthou 1 1,534 15-09-2022, 09:53 AM
Último mensaje: jsarthou
Triste CONSULTA ENDER 3 CAMBIO DE FILAMENTO AL INICIAR EXTRUYE EN LUGAR DE RETRAER manolo_245mx 1 2,355 13-04-2022, 10:45 AM
Último mensaje: Simemart
  Cambiar Gcode al iniciar la impresión Slic3r xero83 3 3,095 22-08-2018, 07:39 PM
Último mensaje: xero83
  Paro al iniciar la impresión redneck450 2 1,471 06-06-2018, 11:59 AM
Último mensaje: redneck450
  Eje z se baja unos mm al iniciar la impresión Bertinolario 9 6,225 18-12-2017, 02:21 AM
Último mensaje: lucas_slam