This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 1 voto(s) - 4 Media
  • 1
  • 2
  • 3
  • 4
  • 5
cableado arduino + tb6600
#21
Hola. Los enlaces a los vídeos no van.

Con respecto a tu problema, la dirección de los ejes se puede invertir con el parámetro $3 del Grbl.

Se ha hablado recientemente del tema en este hilo: https://www.spainlabs.com/foros/tema-CON...o-al-reves

Enviado desde mi MI 6 mediante Tapatalk
  Responder
#22
ok gracias ahora le echo un vistazo pues ya está el eje z invertido gracias ahora ver cuál es la próxima piedra en el camino esto de ser novato es duro jeje
  Responder
#23
Ami me pasaba eso del eje z y era por que se pasaba de pasos por darle mas velocidad de la que podia el motor, prueba a bajar la velovidad del eje z. Ami me funciono
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  CONSULTA TB6600 Conexion tagmindb2f 5 1,865 23-09-2020, 03:12 PM
Último mensaje: dvera16
  Led en ROJO en driver TB6600 Rasta365 6 3,142 26-01-2019, 09:35 AM
Último mensaje: tazma