This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Manchas al imprimir
#1
Me sale esto muy amenudo en mis piezas, por qué podría ser?

[Imagen: bdSLFKI.jpg]
  Responder
#2
Es el punto de inicio o fin de la siguiente capa... posiblemente demasiada retraccion, o que es demasiado lenta, pierde tiempo en esa zona y mientras se acumula el material...

que software usas?
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  Manchas en las piezas impresas Lizana 5 1,688 30-10-2020, 11:10 AM
Último mensaje: Juancho89