This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 1 voto(s) - 2 Media
  • 1
  • 2
  • 3
  • 4
  • 5
CONSULTA movimiento eje Y y X super lentos (con video)
#1
un saludo comunidad, es la primera vez que escribo tambien llevo tiempo viendo vuestro foro bueno mi problema es el siguiente despues de hacer homimg y autonivelacion de cama y a la hora de imprimir pieza  el eje Y y X van super  lentos, tengo metido el sofware skynet v2.3.2 y marlin o arduino 1.8.0 os agradeceria vuestra ayuda, un gran saludo
.
https://youtu.be/YsOKV3pMap0
  Responder
#2
No tengo tu mismo hardware ni mismo firmware, pero si que te puedo dar una pista, puesto que investigando otro tema, se que tu firmware tiene un limitador de velocidad en alguna parte, el cual si lo estableces demasiado bajo, aunque en el fileteador le indiques que vaya mas rápido nunca sobrepasará dicho límite.
Seguro que si googleas un poco encuentras el parámetro exacto
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
Exclamación Problema con mi ANET ET4 (adjunto video) sprein 1 732 07-10-2021, 02:44 PM
Último mensaje: Simemart
  movimiento de cama Jose55 9 1,379 20-03-2021, 12:18 PM
Último mensaje: Simemart
  movimiento de extrusor en anet a8 TheDemo 8 1,330 13-11-2020, 07:48 AM
Último mensaje: TheDemo
  Problema movimiento extrusor kikirikiki 1 1,028 25-09-2018, 05:24 PM
Último mensaje: Simemart
  Movimiento H duro y a saltos. Agumon 7 3,061 24-01-2018, 04:28 PM
Último mensaje: erdeivy