This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 1 voto(s) - 1 Media
  • 1
  • 2
  • 3
  • 4
  • 5
CONSULTA Problema al imprimir en smart controller
Hola, buenos dias! les paso a comentar, compre el reprapdiscount full graphic smart controller y ya lo instale, funciona pero cuando mando a imprimir desde la sd, calienta la cama y el extrusor y cuando tiende a empezar a imprimir se tilda y queda congelado tanto el lcd como la impresora, queria saber que es lo que puede llegar a ser, saludos!

Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  MKS Robin e3d y RepRapDiscount Smart Controller mangelh 2 98 10-12-2021, 09:09 PM
Último mensaje: mangelh
  CONSULTA Ramps 1.4 y LCD Full Graphics Controller mati1608 9 581 06-08-2021, 10:57 PM
Último mensaje: Simemart
  Smart LCD RepRap Ramps 1.4 hectorri 104 26,125 17-11-2014, 10:01 AM
Último mensaje: yo_mismo