This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Control de impresora por red
#21
wakaru como va el tema? lo hiciste finalmente?
  Responder
#22
si! de hecho estoy en el trabajo y acabo de empezar una impresión para que este lista justo cuando llegue a casa (es algo grande)

estoy creando un artículo en la wiki sobre como instalarlo y enchufar la cámara de la Raspberry

Sent from my Galaxy Nexus using Forum Fiend v1.0.1.
  Responder
#23
Ole ole, abra que ir buscando entonces una ya.
  Responder
#24
a todo esto, alguno ha probado a slicear cosas sencillas con la raspi? Tiempo de algún cubo de calibración? XD


Saludos!
  Responder
#25
Por ir informando...

aqui es donde estoy trabajando en el articulo. Todavia esta en boceto, y da un poco de penilla, pero se agradecen las criticas (que no se que tal se me da escribir para los demas... :S )


http://spainlabs.com/wiki/index.php?titl..._Octoprint
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  Impresora jibarizada como cabeza cazada por un cazacabezas Juan V 11 1,258 07-05-2021, 04:16 PM
Último mensaje: Simemart
  Impresora se detiene por fallo en la temperatura arielicho 3 997 21-04-2021, 11:51 AM
Último mensaje: Simemart
  CONSULTA Ender 3 no posee panel de control de motion Fede_7814 3 1,148 21-06-2020, 11:25 PM
Último mensaje: Simemart
  Ender 3 no posee panel de control de motion Fede_7814 0 746 21-06-2020, 01:52 AM
Último mensaje: Fede_7814
  Ender 3 no posee panel de control de motion Fede_7814 0 696 21-06-2020, 01:51 AM
Último mensaje: Fede_7814