This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
DUDA Montando láser en tronxy P802M - Quema demasiado
#1
Buenos días:
Llevo un par de semanas intentando reutilizar mi vieja impresora 3D con un módulo láser.
El problema que tengo es que el láser es cómo si funcionase al 100% de potencia todo el tiempo. Incluso cuando no se envía ninguna orden de "imprimir". Con la impresora en standby.
Adjunto imágenes para mostrar cómo está conectado a ver si alguien me puede orientar para encontrar el fallo:

Esquema de conexión:
[Imagen: esquema.png]

Fotos:
[Imagen: 2022-01-16-20-05-42.jpg]

[Imagen: 2022-01-16-20-03-40.jpg]

[Imagen: 2022-01-16-20-03-55.jpg]

[Imagen: 2022-01-16-20-04-31.jpg]

[Imagen: 2022-01-16-20-04-53.jpg]


Muchas gracias de antemano.
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  Laser no quema faluncho 2 226 23-11-2023, 08:38 PM
Último mensaje: tollino
  CONSULTA Montando mi propio laser co2 nolocrema 2 112 27-03-2023, 01:16 PM
Último mensaje: ehades
  DUDA Laser GRBL no detecta mi máquina laser Hamman84 0 1,003 28-04-2022, 07:24 PM
Último mensaje: Hamman84
  Laser que quema continuo Pedriza 3 825 03-05-2021, 01:18 AM
Último mensaje: Pedriza
  CONSULTA Laser dévil en GRBL Laser fjfsanchez 8 5,600 27-01-2021, 08:53 PM
Último mensaje: Gussos