This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
CONSULTA calentamiento nozzle y cama
#1
Hace un par de dias estaba cambiando el cable flexible de mi artillery x2 y al encenderla quedo mal conectado lo que ocasiono una chispa. Al cambiar nuevamente el cable flexible la temperatura del nozzle se incrementaba al encender la makina llegando a unos 250 grados junto con la cama caliente. cambie el extrusor completo y seguia sucediendo.
vi unos comentarios y decidi encargar una placa nueva pero no estoy seguro si cambiarla o si hay otra opcion para reparar lo sucedido
  Responder
#2
Seguramente el mosfet haya quedado en corto en el mejor de los casos, se puede cambiar ese mosfet por uno igual
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  Como solucionar el sobre calentamiento del hoten en una artillery x1 Edilberto 1 1,763 07-11-2020, 02:37 PM
Último mensaje: Simemart