This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
1mm de mas en la pieza en la base
#1
Buenas,

  acabo de comprarme una anycubic photon mono x y al imprimir tanto con chitubox como cpon el slicer de anycubic me crea1mm de mas sobre la base lo que hace que la pieza no tenga las medidas y por tanto si es para encajar con otra pues no encaja, le ha pasado a alguien o alguien sabe la solucion?,  gracias y un saludo a todos
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  Novato con Anycubic I3 MEGA no imprime, sólo hace base y luego no imprime cotarejo 3 2,832 29-12-2018, 01:18 PM
Último mensaje: Nullz