This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Anicubic mega zero
#1
Me he comprado hace poco una Anicubic mega cero
He hecho algunas impresiones correctamente, pero en una pieza de gran tamaño he tenido un error y se me ha echado a perder después de 24 horas imprimiendo y justo que faena en el último 2 % B2
Cuando voy a calibrar la máquina de nuevo ,resulta que parece que la barra que sube y baja la de el soporte del eje z esta inclinada y no soy capaz de calibrar la mesa, ya que bajando los ajustadores al mínimo roza y arrastra el inyector por el cristal.
Parece que si subo la barra con la mano podría nivelar la mesa, pero resulta que parece que esta pieza no tiene calibración.

Alguien me podría dar algún consejo?

Gracias Smash2
  Responder
#2
Subir un poco el contacto del eje Z, lo suficiente para que puedas ajustar el cero de la cama con las ruedas

Por si no sabes a que me refiero:
[Imagen: topeZ.png]
  Responder