This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
CONSULTA Impresión incorrecta
#1
Buenas compañeros, resulta que he calibrado mi impresora e impreso el cubo de calibrado y todo perfecto, pero me he puesto a imprimir un muñeco y cuando ha llegado a cierta altura es como si se perdiese la impresión, también me ha paso con una mejora de Z la que lleva el rodamiento, todo perfecto pero el final con muchos huecos y muy deforme...os pongo una foto de la última impresión a ver si me podéis orientar un poco, muchas gracias 


[Imagen: 14-C05-D3-E-394-C-4309-A4-F4-D192-B866-D915.jpg]

[Imagen: DCDE4-ABF-1-F75-4325-9-DCB-CECED96726-A9.jpg]
  Responder
#2
Pueden ser muchas cosas.

Cuéntanos un poco más que configuraciones tienes, qué máquina, etc...
  Responder
#3
Solucionado, tras ver varios tutoriales el problema estaba en la configuracion de Cura
  Responder