This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
problema con anycubic
#1
Hola Buenos dias:
Tengo una impresora anycubic i 3mega que hasta ahora me ha ido bien,pero ahora cuando intento imprimir algo que tenga una superficie superior 50 mm hace el el marco y se para.
Agradecido de antemano la ayuda que me podais prestar.
  Responder
#2
Conéctala al ordenador, intenta imprimir desde él y revisa la consola, a ver qué error te da al pararse.

Por lo que comentas, podría ser un mal contacto de los cables del thermistor, o algo similar.
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  Necesito ayuda con mi anycubic photon Lekram 0 649 18-06-2020, 04:25 PM
Último mensaje: Lekram
  CONSULTA problema con anycubic peterfers 0 730 09-02-2020, 12:40 AM
Último mensaje: peterfers