This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Problemas con el hot end
#1
Buenas estoy armando una impreosra 3D y mi problema es que el hotend no calienta, cuando utilice el comando M303 en el pronteface no comenzo a calcular el PID. Y cuando quiero subir la temperatura de manera manual con el pronterface tampoco aumenta su temperatura, y es mas la grafica de temperatura se queda en 0.Utilizo una ramps 1.4 y cuando medi la salida D10 me acusa 0V mientras las salidas D9 y D8 1V. La resistencia del hot end me da continuidad no se si deberia ser asi.

Los motores funcionan todos perfectamente y el extrusor tambien. Si alguien me puede dar una mano o sabe que mas tengo que controlar para determinar la falla se lo agradeceria.
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  Hot Plate - Programable grafisoft 7 2,172 31-01-2014, 02:32 PM
Último mensaje: profesorfrink42