This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
recuperación
#1
hola muchachos, 

[Imagen: Whats-App-Image-2020-06-10-at-8-38-19-AM.jpg]

quiero activar  a mi impresora la recuperación de impresión pero me da un error, y no se como puedo solucionarlo 
por favor necesito ayuda y no se como solucionarlo 
 tengo un arduio 2560
rams 1,4
  Responder
#2
Hola @duvan fma, bienvenido al foro.
Seguramente ese error se debe a que tienes configurado un pin para la detección del Power Loss, pero con una lógica inversa a la correcta por lo que se detecta inmediatamente como activado.
En el archivo Configuration_adv.h, deja así la configuración:

#define POWER_LOSS_RECOVERY
#if ENABLED(POWER_LOSS_RECOVERY)
 //#define POWER_LOSS_PIN   44     // Pin to detect power loss
 //#define POWER_LOSS_STATE HIGH   // State of pin indicating power loss
#endif
  Responder