This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Figuras con rayas de relleno en el exterior
#1
Me esta pasando esto después de actalizar el cura y cambiar el extruzor, aparecen figuras geométricas en el exterior de la figura idénticas al relleno. Tengo una Arnet A8.
[Imagen: IMG-20200505-120541.jpg]
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  aneta 8 error display en rayas continuas jape 1 894 15-07-2020, 01:24 PM
Último mensaje: Simemart
  DUDA Configuración relleno cura. Utku 0 987 27-05-2019, 03:48 PM
Último mensaje: Utku