This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Ayuda con CURA y las paredes
#1
Hola, estoy iniciándome en la impresión 3D, y no tengo mucho en esto ni mucha experiencia, y no se si me pudieran ayudar, tengo un problema cuando pongo los valores en el CURA, la imagen o la vista previa del modelo, las paredes de la figura no se cierran completamente, me aparece mas o menos así. y no se que valores son los que tengo mal, y tampoco se si esto afecta la calidad de la impresión 

Gracias.
[Imagen: Captura-de-Pantalla-2020-03-06-a-la-s-12-57-31.png]
  Responder
#2
Hola, en esa imagen no se ve bien como es la pieza pero, en muchas ocasiones estos problemas suelen ser debidos, más que a una configuración equivocada en el programa de corte, a un fichero STL con errores.
Si tienes Windows 10 y el 3D Builder, puedes cargarlo en él y te indicará si el fichero tiene errores y, si es así, te dará la posibilidad de corregirlos.
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
Estrella CONSULTA Problemas con Soportes en Cura carlie.catt 3 0 20-04-2023, 10:38 PM
Último mensaje: Simemart
  CONSULTA problemas con cura Jose55 8 304 27-09-2022, 07:51 PM
Último mensaje: Jose55
  Puentes con CURA RocaDiesel 3 335 02-01-2022, 05:09 PM
Último mensaje: RocaDiesel
  Problema impresion con cura Youthanasia75 1 902 29-10-2019, 11:57 PM
Último mensaje: Simemart
  Conectar Cura 4.2 con MKS SBASE 1.3 en red pere_gs 1 1,231 08-08-2019, 06:07 PM
Último mensaje: pere_gs