This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
ramps 16 con tmc 2208 uart
#1
hola buenas tengo una impresora 3d prusa i3 que estoy actualizando , esta viene con una ramps 1.6 y he decidido actualizarla a 32 bits con un re-ams y unos tmc 2208 uart . el problema es que al compilar y meterle el firmware me da tmc err conect y al mandar el comando m122 me da all low, sabeis como hacer que esto funcione gracias.Le he puesto los cables en y con resistencia de 1ohmnio , los he conectado en el ext 2 y he añadido la libreria tmc22080 al visual studio code
  Responder
#2
Hola, me parece que no es tan sencillo y hay que hacer algunas cosas más, aparte de lo que indicas.
Dale un vistazo a este hilo.
  Responder


Posibles temas similares…
Tema Autor Respuestas Vistas Último mensaje
  ERROR CONEXION TMC F.B.G. 9 2,167 19-02-2024, 03:24 PM
Último mensaje: Simemart
  CONSULTA Problema con Arduino Mega, RAMPS y TCM2208 V1.2 pepebky 7 511 05-05-2022, 09:20 AM
Último mensaje: Simemart
  DUDA Reparar Uart Btt TFT35 E3 V3 Inderlard 2 374 07-02-2022, 07:25 PM
Último mensaje: Inderlard
  SKR 2 con TMC2209 Error conex. TMC Cayo 4 999 30-08-2021, 03:52 PM
Último mensaje: Cayo
  placa mks gen v1.4 modo uart josesete 4 1,259 21-03-2021, 10:28 PM
Último mensaje: josesete