This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
presentacion
#1
Buenas noches a todos,

Me uno a este mundo del 3d, pero antes me gustaría deciros que soy un informático de sistemas, adicto a la domotica y a los cacharreros, llevo tiempo detrás de adentrarme en este mundo y hoy me he dicidido a comprar (seguro que mal hecho) una impresora 3d, en concreto una gucoco prusa i3 por Amazon ya que el ansia me puede y era la que más rápido me llegaba, y en estos momentos de mucho tiempo libre voy a intentar entrar en este mundo.

Como primer favor me gustaría que me dieseis vuestra opinión sobre mi compra, y posteriormente saber si puedo “vitaminar” mi impresora (siempre y cuando la haga funcionar)

Muchas gracias a todos!!!!

Un fuerte abrazo!
  Responder